Add And Register A Pendant - AT&T CareLine SN1197 Complete User's Manual

Getting started
Add and register a handset
• You cannot register a handset if any other system device is in use.
• The telephone base shows Registration slots are full when you try
to register more than 12 devices to it.
• If you have not set the date and time for the telephone system, the
handset will prompt you to set the date and time after it is registered
to the base. To skip setting, press CANCEL.

Add and register a pendant

When first purchased, charge the pendant in the pendant charger. You
hear three beeps every 10 seconds when the pendant is not registered.
The new pendant should be charged without interruption for at least
30 minutes before registering it to the telephone base.
Make sure the pendant is out of the pendant
charger and turned on.
To register a pendant:
Press MENU on the telephone base
1.
when it is not in use.
or to scroll to Settings, then
2. Press
press SELECT.
or to scroll to Registration, then
3. Press
press SELECT. The telephone base shows
Registering... Please wait.
4. Put the pendant in the pendant charger.
The pendant status light flashes red and
green to indicate the registration is in
progress. Then PENDANT Registered
appears on the telephone base, and both
devices beep. The pendant is now registered
with the telephone base. It takes up to 60
seconds to complete registration.
--:--
Dial mode
RegistrationR
--:--
--:--
PENDANT Registered
16
SETTINGS
BACK
SELECT
Registering...
Please wait
BACK
BACK
--/--
--/--
--/--