Starting Diag; Starting Diag In The Protection Cancel Mode - Yamaha RX-Z9 Service Manual

RX-Z9/DSP-Z9

Starting DIAG

Press the "STANDBY/ON" key of the main unit while simul-
taneously pressing the "BALANCE" key and the "TONE CON-
TROL" key located in the sealing panel of the main unit to
activate the DIAG function.
Starting DIAG in the protection cancel
mode
If the protection function works and causing hindrance
to trouble diagnosis, cancel the protection function as
described below and it will be possible to enter the
DIAG mode. (The protection functions other than the
excess current detect function will be disabled.)
Press the "STANDBY/ON" key while simultaneously press-
ing those two keys indicated in the figure above. At this time,
keep pressing those two keys for 3 seconds or longer.
In this mode, the "SLEEP" segment of the FL display of the
main unit flashes to indicate that the mode is DIAG mode
with the protection functions disabled.
CAUTION!
Using this product with the protection function disabled
may cause damage to itself. Use special care for this point
when using this mode.
34
No. DSP HIF STATUS menu
1 Status (1)
2 Status (2)
3 Stream Info
4 System (PLD, Sel, etc)
5 Mute Info
6 Channel Status (1)
7 Channel Status (2)
8 DIR Info (1)
9 DIR Info (2)
10 ADI Info (1)
11 ADI Info (2)
12 ADI Info (3)
13 YSS930 fs count (1)
14 YSS930 fs count (2)
15 i.LINK Info
The STATUS menu may be displayed with its number increased
by the number of the download codes in the future.
FL Display
ST1
ST2
STR
SYS
MTI
CS1
CS2
DR1
DR2
AD1
AD2
AD3
YS1
YS2
ILK
Turn on the power while pressing these keys.