Memory Module - HP Pavilion 14 Notebook PC Maintenance And Service Manual

Memory module

Description
4 GB memory module (PC3, 12800, 1600 MHz)
2 GB memory module (PC3, 12800, 1600 MHz)
8 GB memory module (PC3, 12800, 1600 MHz)
NOTE: Before adding memory modules, make sure the computer has the most recent BIOS version, and
update the BIOS if needed. For Windows operating systems, see
Linux, see Ubuntu Linux – Using Setup Utility (BIOS) and System Diagnostics on page
Before removing a memory module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service door (see
Remove the memory module:
NOTE: Note the location of the memory module you are removing. If you are replacing it, install the new
memory module in the same slot.
1. Spread the two retaining tabs (1) on each side of the memory module slot to release
the memory module. (The memory module tilts up.)
2. Remove the memory module (2) by pulling it away from the slot at a 45 degree angle.
Battery on page 29).
Service door on page
Updating the BIOS on page
30).
Component replacement procedures
Spare part number
691740-001
691739-001
693374-001
64; for Ubuntu
67.
31