Mantel And Wall Projections; Door Dimensions For Finishing - Outdoor Lifestyles TWILIGHT-II-MOD Installation Manual

HOUSEWRAP (BUILDING
PAPER) AND SHEATHING
SEE FIGURE 10.5
Figure 8.5 Exterior View with Non-combustible Facing Material
B. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specifi ed. Framing closer than the minimums list-
ed must be constructed entirely of noncombustible materi-
als (i.e., steel studs, concrete board, etc.) Failure to comply
could cause fi re.
NON-COMBUSTIBLE BOARD
(SUPPLIED ON APPLIANCE)
INDOOR SIDE ONLY
Figure 8.6 Clearances to a Combustible and/or Non-combustible
Indoor Mantel
24 Outdoor Lifestyles by Hearth & Home Technologies • Installation Manual TWILIGHT-II-MOD • 2290-970 Rev. H • 5/14
DETAIL -
INSULATION
APPLIANCE
HOOD
CEILING
12
11
10
35-3/4
9
8
7
13-5/8
12-5/8
6
11-5/8
10-5/8
9-5/8
8-5/8
7-5/8
HOOD
MEASUREMENTS FROM
TOP EDGE OF THE OPENING
Note: Measurements are in inches.
SOFFIT
SIDING
DRAIN PLANE
DETERMINED BY
LOCAL CODE
12 in.
MINIMUM CLEARANCE
TO NON-VINYL SIDING
36 in. MINIMUM
CLEARANCE TO VINYL SIDING
TOP OF
APPLIANCE
BRICK OR OTHER NON-COMBUSTIBLE
FACING MATERIAL 6 INCH MAXIMUM
PROJECTION FROM SURFACE OF
FIREPLACE (INCLUDES NON-COMBUSTIBLE
MANTEL PROJECTION)
NON-COMBUSTIBLE BRICK LEDGE
MUST BE TIGHT TO APPLIANCE
FACE OR NON-COMBUSTIBLE SHEATHING
TOP VIEW
Figure 8.7 Clearances to a Combustible and/or Non-combustible
Indoor Mantel or Mantel Leg
C. Door Dimensions for Finishing
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used.
35-5/16 in.
MINIMUM CLEARANCE
TO NON-VINYL
64-5/16 in.
CLEARANCE TO VINYL
SOFFIT, OVERHANG, MANTEL,
OR CEILING
TOP OF HOOD
MEASURED
FROM CORNER
1/2 IN.
FIREPLACE
HOOD