Remove The Shipping Materials; Clean The Appliance; Glass Refractory - Outdoor Lifestyles TWILIGHT-II-MOD Installation Manual

Removing Fixed Glass Assembly- Exterior
• Remove vanity panel from appliance to expose glass
latches.
• Pull glass latch out to release. Grasp glass assembly on
sides and pull bottom toward you. Slide glass assembly
down and out from under glass retainer.
GLASS RETAINER
GLASS LATCHES
4.3 Glass Latch Locations - Exterior Side
GLASS LATCH GLASS LATCH
9.2 Glass Assembly - Exterior Side
Replacing Fixed Glass Assembly - Exterior
• Slide top of glass assembly into position under glass
retainer. Position bottom of glass assembly and secure
glass clips.
• Replace vanity panel.
26 Outdoor Lifestyles by Hearth & Home Technologies • Installation Manual TWILIGHT-II-MOD • 2290-970 Rev. H • 5/14
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Glass Refractory
Install black glass refractory panels by carefully sliding
them in between the fi rebox and glass retainer brackets.
See Figure 9.3
Note: Place the glass refractory so that the smooth, re-
fl ective side is facing the inside, or viewing area, of the
fi replace.
Figure 9.3 Install Refractory
USE SLOTS
TO SLIDE
REFRACTORY
INTO POSITION