Removing A Drive Spacer - HP Rack Storage/12 Installation Manual

Chapter 5
1. Insert the two back tabs into the rear slots of the hard drive. Push the drive
spacer back slightly.
2. Insert the front tabs into the slots of the hard drive.
3. Press the drive spacer and hard drive together until the drive spacer is
fully seated.

Removing a Drive Spacer

Remove a drive spacer from the adjacent hard drive if it is not required for the
installation.
1. Slide the drive spacer back slightly to the rear of the hard drive.
2. Tilt up the front of the drive spacer to disengage the front two tabs.
3. Pull the drive spacer forward slightly to disengage the back two tabs
and lift.
Removing and Installing HP Rack Storage/12 Components
Drive Spacer
Figure 5-1. Attaching the Drive Spacer
Tabs
33