Left Cover - Canon imageFORMULA P-215 Service Manual

CHAPTER 3 DISASSEMBLY & ASSEMBLY
Notes on assembling
A figure of the gears' assembling is shown
below.
Figure 3-103
After assembling the pickup tray unit,
place the cable (FPC, FFC) in the right
cover and install it. The mark
bottom of the cover is on the eject side.
Figure 3-104
3-2

3. Left Cover

1) Remove the bottom cover.
(Page 3-1)
2) Insert a tool with thin and flat tip into the
upper and lower holes
and pick the edge of the cover to remove
the fitting parts, then remove the left cover
2
Note: Be sure to insert the tool into the correct
1 on the
COPYRIGHT © CANON ELECTRONICS INC. 2011
.
positions.
Since the left cover may jump out, re-
move it while holding it by hand.
The pickup tray unit and inside gears
can be removed when the left cover is
removed.
Figure 3-105
1 (2 holes each),
CANON P-215 FIRST EDITION