Front Roller (Drive); Registration Roller (Drive) - Canon imageFORMULA P-215 Service Manual

CHAPTER 3 DISASSEMBLY & ASSEMBLY

2. Front Roller (drive)

1) Remove the left cover.
(Page 3-2)
2) Remove the gear
thin tip, unhook the fitting parts
places), remove the central shaft support,
unhook the fitting parts
remove the shaft support at the end and
the front roller 4 .
Figure 3-303
Notes on assembling
Install 2 shaft supports in correct direction,
and push them in until they are fitted
properly. Insert the gear to the end with the
D-shaped hole facing outward. Insert the
gear while rotating it slightly because it is
in the form of helix.
3-10
1 . Using a tool with the
2
3 (2 places), and
COPYRIGHT © CANON ELECTRONICS INC. 2011

3. Registration Roller (drive)

1) Remove the control PCB.
(Page 3-9)
2) Remove 3 screws
(2 M2.5x6) and remove the PCB mounting
plate 2 .
Note: The PCB mounting plate includes a tray
detection lever.
3) Using a tool with the thin tip, unhook 2
pairs of the fitting parts of 4 shaft supports
1 and remove the lower cover
remove the part
holds the upper sensor PCB
Note: The lower cover includes a document
sensor lever.
1 (self-tapping, FH
Figure 3-304
of the lower cover that
3
.
4
Figure 3-305
CANON P-215 FIRST EDITION
2 . Also