Installing The Software; Connecting To A Computer - Canon imageFORMULA P-215 Service Manual

CHAPTER 4 INSTALLATION & MAINTENANCE

3. Installing the Software

Install the following software from the
supplied setup disk that is required in order
to use the scanner.
• CaptureOnTouch
• Scanner driver
• Others
Note: If "CaptureOnTouch Lite" is used, the
above software does not need to be
installed.
Note: The software should be installed be-
fore connecting the machine to a
computer.
The following shows an outline of the
installation on Windows.
1) Login using an account with Administrator
privileges.
2) Before installing the software, exit all other
applications.
3) Load the setup disk into the DVD drive of
the computer.
4) The setup menu starts automatically.
5) Click [Typical Installation].
Figure 4-101
Finish the installation by following the
on-screen messages.
4-2

4. Connecting to a Computer

1) Close the pickup tray and turn the Auto
2) Connect the machine and the computer
Note: The USB port should support USB 2.0
3) Open the pickup tray and verify that the
Note: If the cable is connected to the
Note: Although this scanner supports USB
Note: The scanner cannot be used when it is
COPYRIGHT © CANON ELECTRONICS INC. 2011
Start switch "OFF".
using the supplied USB cable.
or USB 3.0.
Auto Start Auto Start
OFF OFF ON ON
Figure 4-102
power is switched ON.
USB2.0 port, bus power of 5 V 0.5 A is
supplied and if it is connected to the
USB3.0 port, bus power of 5 V 0.9 A is
supplied.
3.0 bus power, USB data transfer rates
remain at USB 2.0 speeds.
connected to a computer via a
bus-powered USB hub. A self-powered
USB hub can be used, but operation is
not guaranteed.
CANON P-215 FIRST EDITION