Rack Mounting ­ (Tlm­170M / Tlm­170Md Only) - Datavideo TLM 170 Instruction Manual

Fitting the TLM­170M / MD to a 19" Rack
The TLM­170 M / TLM­170 MD is designed to rack mount. When folded away it is 1U high, please bear in
mind that when opened for operation the monitor is 6U high, so leave adequate room for this.
The monitor is ready fitted with sliding rack rails, these have a length adjustment at the rear to suit the
distance between the front and rear rack rails of your cabinet.
To adjust the length loosen the four adjustment nuts as illustrated below, and pull the side rails back as far
as is required. Then re­tighten the nuts.
Mount the monitor in your rack with the rear panel facing upwards. Ensure the rack mounting screws are
secured both front and rear.
Once mounted unscrew the two locking screws on either side of the front panel, and pull the monitor forward
using the handle. Once the monitor is fully forward simply hinge it up into a vertical position.
To fold away, pull the top of the monitor forward, so that it hinges down to a horizontal position, then push it
back into the rack until you are able to screw in the locking screws.
N.B. When folding the monitor away be careful not to trap your fingers or scrape your knuckles on
the rack cabinet.