Conair CSC User Manual page 9

DANGER: Sharp blades!
Most injuries caused by knife blades occur
when the cutter has been turned off. Handle
blades with care at all times.
Always wear cut-resistant gloves when the
cutting chamber is open and when handling
blades.
Always lock out the cutter before opening the
cutting chamber.
Always wait until the cutter head has stopped
completely before opening the knife guard.
The puller/cutter combo is equipped with sever-
al safety devices to ensure safe operation.
Never remove or disable these devices to sus-
tain production. Operating without these
devices can cause severe injury.
When the knife guard is opened, the knife
guard switch stops the cutter and prevents
starting the cutter again.
Two proximity-type safety switches prevent
operation unless the cutter bushings are in
place.
The Cutter Stop button activates a circuit that
stops the knife.
WARNING: Improper installation,
operation, or servicing may result in
equipment damage or personal
injury.
This equipment should only be installed,
adjusted, and serviced by qualified technical
personnel who are familiar with the construc-
tion, operation, and potential hazards of this
type of machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your
region. Always maintain a safe ground. Do not
operate the equipment at power levels other
than what is specified on the machine serial
tag and data plate.
UGE048/1103 CSC Combination Puller/Cutter
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
1-3
I
NTRODUCTION