Conair CSC User Manual page 83

WARNING: Voltage Hazard
This equipment is powered by alternating cur-
rent, as specified on the machine serial tag and
data plate. Do not operate the equipment at
power levels other than what is specified on the
machine serial tag and data plate.
A properly-sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the elec-
trical enclosure. Improper grounding can result
in severe personal injury and erratic machine
operation.
Before performing maintenance or repairs on
this product, disconnect and lock out electrical
power sources to prevent injury from unexpect-
ed energization or start-up. A lockable device
has been provided to isolate this product from
potentially hazardous electricity.
DANGER: Sharp blades!
Most injuries caused by knife blades occur
when the cutter has been turned off. Handle
blades with care at all times.
Always wear cut-resistant gloves when the
cutting chamber is open and when handling
blades.
Always lock out the cutter before opening the
cutting chamber.
Always wait until the cutter head has stopped
completely before opening the knife guard.
CSC cutters are equipped with several safety
devices to ensure safe operation. Never
remove or disable these devices to sustain pro-
duction. Operating without these devices can
cause severe injury.
When the knife guard is opened, the knife
guard switch stops the cutter.
Two proximity-type safety switches prevent
operation unless the cutter bushings are in
place.
The Cutter Stop button activates a circuit that
stops the knife.
UGE048/1103 CSC Combination Puller/Cutter
W
ARNINGS AND
C
AUTIONS
CONTINUED
M
AINTENANCE
5-3