Table of Contents
Advertisement
C
UTTER
C
ONTROL
I
NSTRUCTIONS
C
UTTER
C
ONTROL
I
NSTRUCTIONS
T
OTAL
S
CREEN
Continued
4-4
O
PERATION
Menu function key is used to access the Menu Area.
This area can only be accessed from the main display
screen for each mode. See the Menu Area section for more
information.
Parts Select Area Screen
Under the current mode on the left side of the bottom line of
the display is a soft key labeled Parts. Pressing this key
accesses the Parts Select Screen.
SELECT PARTS AREA
Total
Exit
This screen provides access to the parts Total/softkey1 or
Batch/softkey3 areas. Pressing Exit/softkey2 returns the dis-
play to the active main screen. If no selection is made within
30 seconds the display returns to the active main screen.
EXIT or PREV, fixed function keys return the display to the
previous screen.
TOTAL SCREEN
By pressing softkey1 located under the word Total on the
Parts Select Screen, a seven-decade total counter is available.
Additional information on how to access this screen can be
found in the operator display overview in Appendix E of this
manual.
TOTAL 0,000,000 pcs.
Off
Exit
This is typically used to count cut pieces during the day or
days that the product is being produced. Sample or manual
cuts are not counted. When enabled the count continues to
accumulate even if the total display is not being viewed. It is
also possible to turn this counter off or on.
On/Off Softkey1
Under the counter on the left is a soft key labeled On or Off.
Pressing this key while On is displayed will disable the
counter. Likewise pressing this key while Off is displayed
enables the counter.
Exit Softkey2
Under the counter, in the center is a soft key labeled Exit.
Pressing this key will return the display to the Parts Select
screen.
CSC Combination Puller/Cutter
Batch
Reset
UGE048/1103
Advertisement
Table of Contents
