Conair CSC User Manual page 85

Monthly
Checking hardware on the knife guard
Inspect the hardware on the knife guard (fasteners on
hinge and the clear blade guard window). Tighten as
needed.
Checking bushing holder proximity switches
Inspect the proximity switch set screws. Adjust as
needed. See Adjusting the Cutter Proximity Switches,
Section 5.
Cleaning the clear blade guard window
Clean using glass cleaner or plain water. Other materi-
als may cause premature loss of clarity or crazing.
Checking the metal draw latch
Inspect the latch on knife guard for wear and proper
tension. Readjust or replace as needed.
Semi-annual (every six months)
Inspecting electrical terminals
Check all electrical terminals for tightness; adjust as
needed. See Checking Electrical Connections, Section
5.
Checking torque on Trantorque coupling device
Check the tightness (torque) of the Trantorque cou-
pling device with a torque gauge. This device connects
the cutter head to the Micron reducer shaft. See
Checking Torque, Section 5.
Checking all electrical cables
Inspect all electrical cables for cuts and abrasions.
Replace as needed. See Checking Electrical
Connections, Section 5.
Inspecting control panel lights
Check to make sure no LEDs or lights are burned out
on the control panel. Replace as needed.
Checking motor brushes
Inspect the motor bushes. Replace as needed. See
Replacing Motor Brushes, Section 5.
UGE048/1103 CSC Combination Puller/Cutter
P
REVENTATIVE
M
AINTENANCE
S
CHEDULE
CONTINUED
M
AINTENANCE
5-5