Cleaning The Lubrication Tray; Lubricating The Slide Rail - Conair CSC User Manual

C
LEANING THE
L
UBRICATION
T
RAY
L
UBRICATING
S
THE LIDE
5-8
M
AINTENANCE
The lubrication tray is built into the cutter assembly as a sim-
ple method of applying lubrication to your blade during cut-
ting cycles. Depending on cut rate and type of material and
lubrication, the area will need to be cleaned on a regular basis
and the lubricant replaced. Open the knife guard and, using a
shop vac or other similar equipment, remove all liquid and
solids from the cutting chamber and around the bushings.
Replace the lubricant. For more information, see Blade and
Bushing Lubrication, Appendix D.
Lubricant Tray
Check the shafts on the slide rail system. Even though these
R
shafts are stainless steel, it is recommended that a light oil
AIL
(WD-40 or similar) be applied to the shafts as needed. Wipe
off any excess.
CSC Combination Puller/Cutter UGE048/1103