Conair CSC User Manual page 76

S -U
TART P
P
REPARATIONS
CONTINUED
4-34
O
Before you start daily operation of the puller, you should:
See the Maintenance section of this User Guide for detailed
information on daily maintenance procedures.
1
Plug in the power cord
required maintenance.
2
Turn on power to the puller.
cord to restore power after performing any required main-
tenance. Turn the main disconnect to the ON position.
3
Press the green Start button.
start, make sure the E-stop button pulled out in the
extended position.
4
Rotate the speed reference
belt speed.
5
Observe the digital line
speed. (optional)
PERATION
CSC Combination Puller/Cutter
DANGER: Moving Parts Hazard
Take all necessary precautions when working
around moving parts to prevent body parts and
clothing from being pulled into the machine.
Always disconnect and lock out the main
power source before performing maintenance
on the puller.
Never remove or disable safety devices to
sustain production. Operating without these
devices could lead to hazardous conditions
that can cause severe injury.
Inspect the puller belts.
Check puller alignment with the extrusion line.
Assure the floor locks are properly engaged.
Thread the extrudate through the sizing equipment,
puller and an other devices on the extrusion line
puller.
to restore power after any
Plug in the power
If the puller does not
potentiometer to adjust
rate indicator to observe line
UGE048/1103