Connecting A Power Over Ethernet Ip Camera - D-Link DNR-2060-08P User Manual

Section 2: System Setup
The NVR has a built-in PoE switch accessible via the rear panel. This provides both network connectivity and power for up to
eight PoE IP cameras with a single cable.
Note: The maximum power for all connected devices must not exceed 90 Watts.
Step 1
Make sure the NVR is connected to a network via a router or a switch, or directly connected
to a PC. Plug in cameras using the PoE ports on the rear panel.
Step 2
The NVR will boot up and start to record automatically.
D-Link DNR-2060-08P User Manual

Connecting a Power over Ethernet IP Camera

Suggested Setup
13