Operate Cameras With Dome Control - D-Link DNR-2060-08P User Manual

Section 5: Remote Operation

Operate Cameras with Dome Control

Auto Focus (A.F.):
Click on it and the focus of the camera will be automatically
adjusted to show a clearer image.
Set/Go Preset & Run Tour:
The remote monitoring software allows its users to store up to
255 preset points according to the allowance of the supported
dome cameras.
Use Direction buttons to pan/tilt dome camera to an
appropriate position. Then click this button, select Set Preset
and choose a preferred number from the pull-down list. The
preset point is named as the selected number.
Click this button, select Go Preset and choose a preferred
number from the pull-down list to call the preset point for
viewing.
Click this button, select Run Tour and the dome camera will
start the tour set previously at the dome camera side.
Dome ID (ID):
Click for changing the dome ID and protocol. Proper authority
is required to access this function.
Focus +/−:
Use to adjust the camera lens to focus on objects for a clear
view. Click on Focus + to focus near or Focus − to focus far.
Iris +/−:
This item is used to open and close the iris to let more or less
light into the camera. Click on Iris + to open iris or Iris − to close
iris.
Zoom +/−:
Users are able to zoom-in or zoom-out using the adjusting
buttons. Zoom-in to enlarge a certain area and zoom-out to
view more area.
Direction Button:
This button is used to pan and/or tilt the dome camera. Click
the arrows in the directions to be viewed.
D-Link DNR-2060-08P User Manual 86