Restoring The Original Factory Settings - Kenwood VR-509 Instruction Manual

5 From the remote control unit of the other source, press the key
38
that you want to store.
• The remote code is sent to the remote control unit.
• "Complete" appears when finished.
Complete
>Extend1
• When it takes for more than 5 seconds or the remote control unit does
not receive the remote control code well, "Error" appears in the
display. In this case, re-operate from step 1.
6 The remote control code is stored on the key of the remote
control unit.
To delete the memory stored on the key
Press the display operation 1 [Clr] key in step 4. "Cleared"
appears in the display.
The memory previously stored is cleared.
To operate other components
1 Press the MUSIC, MOVIE, or TV key to select the desired input
source.
2 Press the desired key.
Storing on the memory
You can store on the remote control unit up to 5 memories.
1 Point the infrared ray system part of the other remote control
unit to the remote sensor of the remote control unit .
2 Press the MUSIC, MOVIE, or TV key to select the input of the
desired remote control unit.
Video1:
VCR
Menu
Selected input
3 Press the LEARN key.
• The Extend selecting display appears.
When the setup code is registered
>Extend1
>Extend2
Home Enter
• When the setup code is not registered, any messages do not appear.
4 Press the 5/∞ keys to select the location.
• Extend1 – Extend5 are available.
5 Press the display operation 2 [Enter] key.
• The remote control is sent for receiving the remote control code.
Waiting
>Extend1
Clr Exit
Remote control
unit of the other
source.
Infrared ray system part
6 From the remote control unit of the other source, press the key
that you want to store.
• The remote code is sent to the remote control unit.
• "Complete" appears when finished.
Complete
>Extend1
Extend 1
• When it takes for more than 5 seconds or the remote control unit does
not receive the remote control code well, "Error" appears in the
display. In this case, start from the step 1 again.
7 The remote control code is stored on the memory (Extend1 –
Extend5) of the remote control unit.
To delete the stored memory
Press the display operation 1 [Clr] key in step 5. "Cleared"
appears in the display and the memory that is selected in step 4
is erased.
To operate other components by using the stored memory
1 Press the MUSIC, MOVIE, or TV key to select desired input
source.
2 Press the display operation 2 [MENU] key during "Menu"
appear in the display.
• The Menu display appears.
3 Press the 5/∞ keys to select the memory you want to operate.
4 Press the display operation 2 [Enter] key.

Restoring the original factory settings

You can restore the setup codes or memories to their original default
settings.
2
Insert the batteries while pressing and holding the 5 key
and 2 key.
• "Cleared" appears in the display, and the remote settings return to
their original default settings.
• To maintain the memory settings, complete the battery replacement
operation approximately within 10 minutes.
Remote control operations
5