Operating Other Components - Kenwood VR-509 Instruction Manual

@
Press the display operation 2 [Enter] key.
34
• The display returns to the setup display.
>01.IR
>02.Surround
Home Enter
Repeat steps 3 to @ to register additional components
until all components have been registered.
To returns to the initial display, press display operation
1 [HOME] key repeatedly until " Menu " appears in the
display.
Video1:
VCR
Menu
• Once registered, the display on the receiver shows the component
type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 jacks, "Video1" and
"VCR" appear in the display.
• Any VIDEO or TV (TV1, TV2, CABLE) inputs that have not been
programmed with a setup code or Non-IR code are deleted from the
cyclic list.
When you make a mistake
Press the display operation 1 [Back] key repeatedly until the display
you want to re-operate appears.
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models. (Also, certain
codes may only operate some of the functions available on a given
model.)

Operating other components

This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections.
SHIFT
AV POWER I /
During operation, make sure you start the next step within 8
seconds of completing the previous one. If more than 8
seconds elapse between any two steps, press the display
operation key so that the display appears.
1
Use the MUSIC, MOVIE, or TV key to select the component
you desire.
• Pressing the MUSIC or MOVIE key also changes the input selector
on the receiver. If you do not want to change the current input, press
the SHIFT key before step 1.
MUSIC key MOVIE key
1 CD/DVD 1 Video1
2 TAPE or MD 2 Video2
3 Tuner 3 Video3
4 PHONO 4 DVD 6CH
5 AV AUX
Video1:
VCR
Menu
Select source
• You cannot select the source that is not registered.
2
Press the AV POWER
• The selected component turns on or off.
3
Press the operation keys you desire.
• See "Remote operation of other components" at the end of this
manual for a list of keys available with each component.
The remote control mode remains in the set at the component
selected in step 1 mode until you select another component.
Note
Be sure to point the remote control at the remote sensor on the receiver
when you want to operate KENWOOD components connected by
system control cords. Otherwise, point the remote control at the compo-
nent you want to operate.
Remote control operations
MUSIC, MOVIE,
TV
+ +
– –
TV key
1 TV1
2 TV2
3 CABLE
key.
‚