Preparing For Surround Sound; Speaker Settings - Kenwood KRF-V7050D Instruction Manual

Preparing for surround sound

Speaker settings

To enable you to obtain optimum enjoyment from the receiver's listening
modes, make sure to complete the speaker settings (subwoofer, front,
center, and surround speakers) as described below.
MULTI CONTROL
SET UP
POWER ON/STANDBY (
SET UP
1
Turn on the power to this receiver by pressing POWER and
ON/STANDBY ( ) keys.
2
Select a speaker system.
1 Press the SET UP key such that the subwoofer setting
indication "SUBW ON" appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
2 Use the MULTI CONTROL knob or keys to select the appro-
priate subwoofer setting.
1 SUBW ON: Subwoofer setting mode to the receiver is ON.
2 SUBW OFF: Subwoofer setting mode to the receiver is OFF.
• The initial setting is "SUBW ON".
• When "SUBW OFF" is selected, the front speakers are automatically
set to "FRNT LRG" and the procedure skips to step 5.
• When subwoofer output sound is required, select "FRNT NML".
3 Press the SET UP key again to accept the setting.
• The front speakers setting indication "FRNT" appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
4 Use the MULTI CONTROL knob or keys to select the appro-
priate front speakers setting.
1 FRNT NML (normal): Average size front speakers are
2 FRNT LRG (large):
• For "FRNT LRG" selection, no sound will be heard from SUBW
even when it is set to ON. However, if you select CINEMA EQ.
when subwoofer is selected, you will be able to hear sound from
the subwoofer.
When in STEREO mode, the sound goes directly to front speaker.
5 Press the SET UP key again to accept the setting.
• The center speaker setting indication "CNTR" appears.
)
MULTI
CONTROL
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
kHz DOWN MIX DSP TUNED
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
ST.
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP TUNED
connected to the receiver.
Large front speakers are connected
to the receiver.
6 Use the MULTI CONTROL knob or keys to select the
appropriate center speaker setting.
If you have selected "LRG" as the front speakers setting,
1 CNTR LRG (large):
2 CNTR NML (normal): An average size center speaker is
3 CNTR OFF:
If you have selected "NML" as the front speakers setting,
1 CNTR ON:
Center speaker setting mode to the receiver
is ON.
2 CNTR OFF: Center speaker setting mode to the receiver
is OFF.
7 Press the SET UP key again to accept the setting.
• The surround speaker setting indication "SURR" appears.
8 Use the MULTI CONTROL knob or keys to select the
appropriate surround speaker setting.
If you have selected "LRG" as the center speaker setting,
1 SURR LRG (large):
2 SURR NML (normal): Average size surround speakers are
3 SURR OFF:
If you have selected other than "LRG" as the center speaker
setting,
1 SURR ON:
Surround speaker setting mode to the
receiver is ON.
2 SURR OFF: Surround speaker setting mode to the
receiver is OFF.
9 Press the SET UP key again to accept the setting.
• The receiver enters the speaker volume level adjustment mode.
• In steps 3 and 4, indications appear only for the selected
channels of the speakers that require adjusting.
3
Adjust the speaker volume level.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
1 Use the MULTI CONTROL knob or keys to adjust the
volume level of the test tone output from the speaker
channel to be adjusted.
The channel indication blinks while the test tone is being output.
SP A B TI.VOL
L C R
CLIP MUTE
LFE
RDS EON PTY
LS S RS
TP TA NEWS
The test tone is heard from the speakers for 2 seconds at a
time in the following sequence for 2 seconds each:
• If you change the volume level settings for the speakers while
listening to music, the settings referred to on this page are also
changed.
• If the speaker setting selects are OFF, the speaker level
settings are reset.
2 Press the SET UP key.
• The test tone is turned off. The receiver enters the mode for
inputting the distance to the speakers.
A large center speaker is connected
to the receiver.
connected to the receiver.
Center speaker setting mode to the
receiver is OFF.
Large surround speakers are
connected to the receiver.
connected to the receiver.
Surround speaker setting mode to
the receiver is OFF.
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
kHz DOWN MIX DSP TUNED
ª
Continued to next page
17