Armrest Support Assembly - Invacare Spectra Plus Technical Manual

Spectra Plus Tech Manual Section

ARMREST SUPPORT ASSEMBLY

Armrest Support Assembly Replacement
I. Remove armrest from chair.
II. Remove panel mounting bracket (1b, 2, or 3) by releasing M.8 grub screw (c).
III. End plug ( d & e ) may be prised from the tube using a thin blade etc.
Re-assembly is the reverse of the above procedure. If suitable, gently tap and bungs ( d & e ) back into position.
Upholstered Armpad Replacement – Adjustment
The armrest pad can be located on the armrest support assembly to achieve the most suitable forward or rear
position for the occupant. (Ref. to above diagram).
The armrest can also be and crossed over to account for the variations and reduction width.
To remove, loosen the two M.5x35 bolts (f) fixing the armrest pad to the support tube. Tighten to secure. Do
not overtighten as this will result in the T-unit insert becoming ineffective.
When the double/treble panel mounting bracket (2 or 3) is fitted to reduce the overall seat width, crossover
the armpads from side to side if required.
19/01/2004 Page 21 of 78