Backrest Support Assembly - Invacare Spectra Plus Technical Manual

Spectra Plus Tech Manual Section

BACKREST SUPPORT ASSEMBLY

Single And Combined Backrest Support
(Standard, Swan-Neck And All Variations)
The backrest support can be folded down or detached for improved portability. (Refer to the User Manual for
this procedure).
Replacement
Replacement backrest assemblies are supplied complete with handgrips and locating components, if the hand
grips require, cut through with a sharp blade and peel off.
The replacement handgrips must be secured with a recommended adhesive (e.g.3 M's Scotchgrip). Thoroughly
check to ensure that the handgrip does not rotate or slide on the backpost handle.
If the locating components require replacement follow this procedure:-
Loosen grub screw (a) and tap out locating cross pin (b), reinforcing plug (c) can now be removed.
Replacement/re-assembly is the reverse procedure. Insert reinforcing plug (c) and line up locating holes.
Screwlock and securely tightened into the cross pin.
19/01/2004 Page 23 of 78