Specification - Invacare Spectra Plus Technical Manual

Spectra Plus Tech Manual
Anti-Tip Levers
Armests
Semi-reclining Backs
Crossbar: Check
Crossbar
5. BATTERIES.
Batteries:
Battery Box
Junction Box if Fitted
(Powered actuators)
Control Main Module
(Remote)
6. MOTORS
Mountings
Armature Brakes
Wiring & Connections
Brushes
7. FINAL DRIVE
Disengage
Mechanism
19/01/2004
Check fixings and operation. Make sure wheel is in position. Replace if
missing or damaged.
Inspect all fittings and scews. Ensure arm locates into sockets smoothly.
Check operation of locking devices. Ensure controller moves freely in slide
tube. Check for correct position of stop screw. Check sidepanels for
correct position and wear.
Check Fittings and forward folding/detachable operation. On powered
reclining backs check function and mounting actuator, inspect cable and
hand unit. Check backpost mounting brackets for tightness. Ensure both
sides are in same position.
Centre fixing is not overtightened. Lubricate at hinge points to sideframe
using WD4O.
Check batteries for capacity. Replace if below specification.
Check battery terminals are tight. Apply silicon grease or petroleum jelly to
terminals.
Inspect battery box and lid. Ensure lid is secure.
Check mounting of junction box to battery box. Inspect wiring harness from
junction box to actuator module. Check operation of circuit breaker. Check
motor socket fittings.
Check Mounting of Controller output module to battery box tray. Check
multi-pin connector for fit. Make visual inspection of main module for
damage. Inspect warranty seal. Check battery tray fittings, ensure secure
mountings. Check programme is correct.
Inspect motor mountings and fittings. Check funtion of detach facility and
securing of knob. Lubricate sliding contact.
Life rear of chair and mount on blocks. With drive engaged run motors
return control lever to the central position and observe operation of
brakes. Blow out dust from brake lining.
Check connections to battery box, make sure the latches are holding the
sockets and plugs in position. Check for discolouration and burning of
contacts (evidence of poor contact replace if burning excessive). Inspect
wiring and entry to motor brake up.
Remove brush covers from sides of motors, observe position of brush in
holder. Re-locate in same position. Run motors with drive disengaged and
observe brush contact with armature. Blow out carbon deposits, replace
brushed if less than 8mm in length.
With wheels raised from the ground engage and disengage final drive, check
for positive re-engagement of lever
Section
Page 7 of 78