Kenwood NV-701 Instruction Manual page 38

38
4
Start programmed playback.
ENTER
(Playback starts from the first programmed
track (program step number 1))
÷ Press the MULTI CONTROL keys during program
playback to go to the previous or next programmed
track.
÷ When the left MULTI CONTROL key is pressed once
during playback, the track being played will be played
from the beginning.
Press the TIME DISP. key on the remote control unit
to switch the time display.
Check the programmed tracks (and replace,
add, or delete tracks as required).
After a program has been made
1
Select "CD Program Play" for pro-
gram editing.
MULTI CONTROL
MENU
DEMO
To check:
MULTI CONTROL
P - 0 1 D 1 T 0 1
÷ The programmed tracks are displayed in sequence.
To replace a track in the program:
MULTI CONTROL 1 Select the programmed disc
or track to be replaced and
press the SET key.
2 Select a disc or track to replace
SET
the disc or track selected above
(step 3-1 and 2).
P - 1 0 D 2 T 0 7
P - 1 0 D 2 T 0 7
÷ The blinking item can be replaced.
To add a track to the program:
MULTI CONTROL
SET
÷ The added track number is added to the end of the
existing program.
To delete a track from the program:
MULTI CONTROL
SET
SET
2
Finish editing and start playback.
To quit the program mode
1
Select "CD Program Play".
2
Press the MENU key.
÷ If the MENU key is pressed during playback, normal
playback in the order of tracks resumes from the
current track.
÷ The program mode can also be canceled by pressing
the OPEN/CLOSE (0) key.
Special playback options for CD
1 Select the display as shown
on the left, and press the SET
key.
2 Perform the same operation
as in step 3-1 and 2 on the
previous page.
Display when 12 tracks have been programmed
P - 1 3 D ? T ? ?
1 Select the programmed disc
of the step to be cleared and
press the SET key.
2 Select "Clear" and press the
SET key.
P - 1 2 D 1 T 0 3
P - 1 2 C l e a r
ENTER
MENU
DEMO
MENU
DEMO
ENTER
SET
Goes off
PGM