Power Connector Cable - HP ENVY 15 Maintenance And Service Manual

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Service cover (see
b. Top cover (see
c. Display assembly (see
d. Top speakers (see
e. System board (see
Remove the power connector cable:
1. Turn the base enclosure upside down, with the rear panel toward you.
2. Release the power connector cable (1) from the clips (2) and routing channel built into the
base enclosure.
82 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
Battery on page 35), and then remove the following components:
WLAN module on page
Top cover on page 47)
Display assembly on page
Top speakers on page
System board on page
42)
56)
69)
72)
Spare part number
668826-001
ENWW