Card Reader Board - HP ENVY 15 Maintenance And Service Manual

Card Reader board

NOTE:
Description
For use on computer models equipped with USB 3.0 capability
For use on computer models equipped with USB 2.0 capability
Before removing the Card Reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the top cover (see
Remove the Card Reader board:
1. Release the ZIF connector to which the Card Reader board cable is connected, and then
disconnect the Card Reader board cable (1) from the system board.
2. Detach the Card Reader board cable (2) from the base enclosure. (The Card Reader board cable
is attached to the base enclosure with double-sided tape).
3. Remove the two Phillips PM2.0×2.8 screws (3) that secure the Card Reader board to the
base enclosure.
ENWW
Downloaded from LpManual.com Manuals
The Card Reader board spare part kit includes the Card Reader board cable.
Battery on page
Top cover on page
35).
WLAN module on page 42).
47).
Spare part number
689592-001
668838-001
Component replacement procedures
67