Setup For Controlling Av Components; Assigning The Connected Components To The Selected Inputs - Kenwood KRF-V7771D Instruction Manual

Setup for controlling AV components

Assigning the connected components to the selected inputs

General setup flow
1 Open the "Setup" menu and select "IR" icon.
2 Assign the connected components to the dis-
played inputs.
3 Assign all the connected components.
1
Open the "Setup" menu and select "IR" icon.
Main
Menu
Phono CD1 CD2
1
TV1 TV2 Video1 Video2 Video3
Lstn Mode Snd Fnc S t p
Lsn Snd
Fnc
Surround
IR
3
Download
Back Li g ht
2
Assign the connected components to the displayed inputs.
Select an input jack name, consult the Setup Codes chart (on the attached sheet) to find out the setup code of the
component connected to the selected input, and enter the 4-digit setup code to assign it to the selected input.
1
Setu p IR
Input
MD/Tape1
selector
1 2 3
0
4 5 6
7 8 9
When registering setup codes for KENWOOD audio compo-
nents which are connected to this unit by system control
cords, use the following codes to insure proper system control
operation:
Cassette deck : 7990
Single CD player : 8990
Carrousel CD player : 8991
Multiple CD player (OUTPUT A to CD 1 jacks)
Multiple CD player (OUTPUT B to CD2/TAPE2 MONITOR jacks)
: 8993
MD recorder : 9990
*1 This code is only for OUTPUT A operations and for a multiple CD
player which does not have separate outputs such as OUTPUT
A and B.
*2 This code is only for OUTPUT B operations. For a multiple CD
player which does not have separate outputs such as OUTPUT
A and B, use codes on the Setup Code chart.
To delete a setup code
3
Assign all the connected components.
Repeat step 2 for each component connected.
MD/ CD2/ Input Input
Tape1 Tape2 Digital Analog
Tuner
Remote
Macro
Mode
Video4 AV AUX
2
S e t u p
Input
Macro
MD
Component
Entr
#9990
4
Clr
Check
2 3
*
: 8992 1
*
2
¡
The TV icons that appear on the segment screen after the
setup allow you to use the remote control to control your TV
without connecting it to the receiver as an input.
1 Select the "Main Menu" icon.
÷ If the "Setup" menu screen shown on the left has already been
appeared, step 1 can be skipped.
2 Select the "Stp" icon.
3 Select the "IR" icon.
1 Select the
or icon to select an input.
CD1
MD/ Tape 1
The inputs are switched every time
CD 2/Tape 2
the
TV1
TV2
Video1
Video2
Video3
Video4
2 Find out the setup code of the actually connected compo-
nent from the Setup Codes chart and input the code using
icons 1 to ).
3 Select the "Check" icon to test the component.
÷ If the proper code has been entered, the component's power will
turn on. However, the components which have one of the codes
shown on the left and some components from manufacturers
other than KENWOOD cannot be turned on.
÷ Select "Clr (Clear)" icon to cancel.
4 Select the "Entr (Enter)" icon to register the code.
÷ Icons of the registered components appear on the segment
screen.
KRF-V7771D (En/T)
or icon is selected.
19