Unpacking The Equipment; Required Tools; Hardware Kit (Not To Scale) - Precor PRECISION SERIES Quick Start Card

Unpacking the Equipment

The treadmill is carefully tested and inspected before shipment. The unit is
shipped in two boxes. Ask for help from two or more people to unpack and
assemble the treadmill. If any items are missing, contact your dealer.
WARNING
Do not attempt to move the equipment by yourself. Have at
least one other person help you and use proper lifting
techniques.
To unpack the equipment:
1. Carefully cut and remove all plastic straps that secure the cover on the
cardboard box.
2. Lift the cover upward and set it aside.
3. Pull the cardboard or foam spacers away from the equipment and set them
aside.
4. Cut all plastic ties securing the equipment in place.
5. Remove the base frame assembly from the container and set it on the floor
where you plan to assemble and use the equipment.
Before you begin, verify that you have received the following parts:
Console box

Large box

–
Base frame assembly
–
Left and right upright supports (shipped in cardboard box packed beneath
the base frame assembly)
–
Smaller box contains:
 Console bracket
 Dash and handrail assembly
 Dash buckets
 Hardware kit
 Assembly Guide
 Stop key and clip
Getting Started

Required Tools

17 mm open-end wrench

Level


Hardware Kit (not to scale)

The hardware kit shipped with this equipment contains the fasteners and other
hardware components shown in the following table. Before you begin assembly,
make sure that your hardware kit is complete. If not, please contact Precor
Customer Support.
Table 1. Hardware kit contents
Fasteners
5 mm hex key
⁵ ₃₂-inch hex key
Buttonhead cap screw
(M8 x 15 mm)
Buttonhead cap screw
(M8 x 12 mm)
Buttonhead cap screw
(¹ ₄-inch x ⁵ ₈-inch)
Socket head cap screw
(M8 x 15 mm)
Flat washer
(8 mm internal diameter)
Quantity
1
1
10
3
4
4
17
3