Settings That Require Individual Configuration - Sony Ipela NSR Series Installation Manual

Setting Scheduled
recording
Data storage Not changed from
location existing configuration.
Audio Depends on the settings
configured in the
[Audio] tab.
Data Not changed from
overwrite existing configuration.
Cleanup Deletes data that
exceeds storage
duration.
1) Depending on the camera model, the values configured for
the Schedule Record settings in the [Video] tab may be
used.
2) If the user has not configured storage location settings for
the camera, the capacity on the first partition of the unit's
internal hard disk is used to calculate other settings. If the
user has configured storage location settings, the capacities
for each of the locations are used to calculate other settings.
Caution
• If schedule recording and alarm recording settings
already exist when you execute "automatic record,"
the automatic configurations replace the previous
settings.
• When you change the camera storage locations, the
settings are not changed automatically. You can
perform basic configuration again to recalculate the
settings.
Settings that Require Individual
Configuration
Further configuration is required in the following cases.
Storage location settings
Under basic configuration settings, data is stored on the
first partition of the unit's internal hard disk.
For details on recording data to an optional NSRE-S200
unit or to other partitions, refer to the User's Guide
(PDF).
When constructing systems that include
multiple NSR units or RealShot Manager
Advanced servers
When configuring multiple servers, individual
configuration is required. For details, refer to the User's
Guide (PDF).
26
Step 3: Settings
Alarm recording
Not changed from
2) 2)
existing configuration.
Depends on the settings
configured in the
[Audio] tab.
Not changed from
existing configuration.
Not changed from
existing configuration.
Pan, tilt, and zoom settings for analog cameras
Configure pan, tilt, and zoom settings for analog
cameras as follows from the [Control] tab of Device
Configuration.
1 23
1 Select the analog camera.
2 Select a protocol based on the analog camera's
settings.
3 Enter the control number configured on the selected
analog camera.
Note
To configure these settings, you must configure the
transmission mode in the "Serial Port" settings of the
Setup Wizard beforehand.
Audio settings for cameras
Under basic configuration settings, audio is disabled.
For details on enabling audio, refer to the User's Guide
(PDF).