Sony Ipela NSR Series Installation Manual page 22

Set the IP address for LAN connector 2, and click
[Next].
↓
Set the IP address for LAN connector 3, and click
[Next].
↓
22
Step 3: Settings
Configure settings for monitor 1, and click [Next].
• If you select [Auto], the type of monitor connected
and its resolution are detected and configured
automatically.
For details on supported resolutions, see "System
Requirements" (page 5).
• When connecting two monitors to the unit, select the
[Dual Head] check box.
Note
When an HDMI monitor is connected, the image may be
compressed to fit the screen and text may appear blurry,
even if you adjust the resolution of the monitor and the
resolution of the image data to match. You may be able
to improve the image quality by selecting the [Dot By
Dot] check box so that each pixel of image data is
displayed as one dot on the monitor, without expansion
or compression processes. You may also need to
configure settings on the monitor side. Refer to the
operating instructions for your monitor.
↓
If connecting a second monitor, configure settings for
monitor 2.
After configuring settings for the second monitor, restart
the unit while the second monitor is connected
↓
Select the audio output connector to use, and click
[Next].
↓