2 off L/H Burner
Retaining Screws
four burner retaining screws as indicated in Fig. 15 above
f)
Slide the burner assembly to the right, off the injector and remove the
from the firebox.
4.3
REMOVING THE CONTROL TAP FROM THE FIRE
a)
Disconnect the appliance from the gas supply.
b)
Remove the burner assembly as shown in section 4.2.
c)
Disconnect the pilot pipe, inlet pipe,valve to injector pipe and push fit
thermocouple as shown below in Fig. 16
Fig. 16
Push Fit
Thermocouple
Fig 15
2 off R/H Burner
Retaining Screws
e) Remove the
Pilot Pipe
Inlet Pipe
Valve to Injector Pipe
19