Manual Ignition - Harman Accentra 52i Owner's Manual

F. Manual Ignition
Figure 4.8
1. Fines are small pieces of broken pellets (sawdust). Fines do
not flow easily and often build up on the hopper funnel bottom
angles. These fines can be pushed into the feeder opening and
then fill the hopper with pellets. As the system works, they will
be burned.
2. The "TEST" cycle will operate the feeder motor for exactly one
minute. Turning to "TEST" again and again may load too much
fuel into the burn pot causing excessive smoke on start-up.
3. The low pressure switch will not allow the feed motor to operate
if the viewing door is open.
4. Adjust Feed Rate. If this is your first fire or you are trying
different pellets, set the feed adjuster to #4, Figure 4.8. This is
a conservative number and will probably need to be increased.
After you know a feed rate setting that works well, use that
setting. Remember, if your feed rate is too high you may waste
fuel.
5. Setting the feed adjuster # for maximum burn: With the unit
burning in "AUTO", turn to "Stove Mode" and put the fan on "H".
Set the Temperature Dial to #7. Allow the unit to burn for about
30 minutes and check ash on front of burn pot. Figure 4.9. If
the ash line is larger than 1", turn the feed adjuster from #4 to
#5. Allow another 30 minutes of burn time and check again. If
, at #6 setting, a 1" or less ash bed is not obtainable, it is not
a problem. The 1" ash bed is only at maximum burn rate and
during normal operation, the ash bed will be larger.
15
See Note 7
1"
Figure 4.9
Harman® • Accentra 52i Owner's Manual_R8 • 2013 -___ • 07/14
Igniter Switch to "MANUAL" (down position) Make
sure the unit is plugged into a 120 VAC, 60 Hz electrical
source. The power light should be the only light lit.
NOTE: Be sure there is no fuel or other combustibles in
the ash pan prior to lighting.
1. Turn FEED ADJUSTER to desired feed rate. No. 4 is good
for most pellets.
2. Turn the MODE SELECTOR to "OFF" and then to
the desired mode. This will reset control and start the
combustion motor.
3. Turn the TEMPERATURE DIAL to the desired setting.
4. Clean burn pot with scraper if necessary.
5. Fill burn pot with pellets, only level with front edge. (Do
Not Over Fill).
6. Add starting gel on top of the pellets. Stir gel into pellets
for fast lighting.
7. Light starting gel with a match, and close the door.
Operation will begin when the fire reaches the proper
temperature.
8. Fill hopper with pellets and remove ashes as required.
Store fuel in a dry area, away from all ignition sources and
outside all limits of the stove's clearance requirements to
combustibles. Do not store the fuel were it interferes with
the refueling of the stove or emptying of ashes. Do not store
any ashes removed from the stove near the fuel or other
combustible materials.
!
BURNING GARBAGE, USE OF IMPROPER FUELS,
FIRE STARTERS OR ALTERING THE STOvE FOR
HIGHER HEAT OUTPUT MAY CAUSE DAMAGE TO THE
STOvE AND COULD RESULT IN A HOUSE FIRE. USE
ONLY APPROvED FUELS AND FOLLOW ONLY THESE
OPERATION GUIDELINES.
!
NEvER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR 'FRESHEN UP' A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL
AWAY FROM THE HEATER WHILE IN USE.
WARNING
WARNING
3-90-00574c