Connecting The Speakers - Kenwood VRS-N8100 Instruction Manual

Setting up the system

Connecting the speakers

CAUTION
Make sure that the power cord plug is disconnected from the AC
wall outlet before proceeding to speaker cord connections.
If the conductor wires on the extremity of speaker cord are
untwisted, there is a risk of short-circuiting. Be sure to twist
them well before connecting the speaker cord.
Front Speakers
Right
R FRONT
14
EN
Left
Right
Center
Speaker
SPEAKERS (6-8Ω)
CENTER SURR R
SURR BACK SURR L
/SW
L
Whether each speaker is connected properly can be
confirmed by outputting the test tone and checking if
each speaker channel outputs audio. For details, see
"Speaker settings" (Step
level).
Protection circuitry
This unit incorporates protection circuitry, which may be activated
during high-power reproduction or in case of extreme rise in tempera-
ture.
When the protection circuitry is activated, the output from this unit is
shut down and the STANDBY indicator blinks.
In this case, turn this unit OFF then ON again and reduce the output
volume level.
Surround Speakers
Be sure to connect both surround speakers.
Surround Back Speaker
When the surround back speaker is connected to
these terminals, set the speaker setting to "BS/
SW Amp Back Surr.".
In this case, the subwoofer should be connected
Left
to the PRE OUT SUBWOOFER jack.
Subwoofer
When the subwoofer is connected to these termi-
nals, set the speaker setting to "BS/SW Amp
Subwoofer".
In this case, two surround back speakers should be
connected to the PRE OUT SURROUND BACK
jacks.
6
Adjust the speaker volume