Connecting Ethernet Cable; Connecting Wireless Lan - Kenwood VRS-N8100 Instruction Manual

Setting up the system

Connecting Ethernet cable

When not using a broadband router or hub, connect this unit directly to
the PC using a cross Ethernet cable. In this case, it is required to set the
IP address and subnet mask manually.
ETHERNET
*
Ethernet cable
Broadband
router
Ethernet cable
PC:
Windows XP Professional SP1,
Windows XP Home Edition SP1,
Windows 2000 Professional SP4 or after.
*
Please refer to the instruction manual of your router or hub. Depending on your router or hab they may in rare case not work with
a cross Ethernet cable.
÷ This unit is not provided with the Internet connection facility.
÷ When this unit is connected to a PC, FM broadcast reception may be interfered with noise. In this case, try the following remedial actions.
1. Increase the distance between this unit and the PC.
2. When the provided FM indoor antenna is in use, replace it with the FM outdoor antenna.
3. Replace the Ethernet cable with a shielded cable.
10
EN

Connecting wireless LAN

Connect the wireless Ethernet bridge to the ETHERNET jack on the rear
panel.
To AC wall outlet
Ethernet cable
Modem Ethernet cable
To
Internet
Modular cable
ETHERNET
*
Ethernet cable
Wireless Ethernet bridge
Wireless broadband router
PC:
Windows XP Professional SP1,
Windows XP Home Edition SP1,
Windows 2000 Professional SP4 or after.
Ethernet cable
Modem
To
Internet
Modular cable