Kenwood VRS-N8100 Instruction Manual page 32

Normal playback
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the "CLIP" indicator
will lights up to indicate the source signal. Adjust the input level.
1 Press the RCV Mode key on the remote control unit to set
it to the receiver control mode.
2 Press the Sound key.
3 Use the MULTI CONTROL @ / # (or the Multi @ / # keys) to
select "ANALOG INPUT LEVEL", and press the ENTER (or
the Enter key).
4 Use the MULTI CONTROL % / fi (or the Multi % / fi keys)
to adjust the input level.
A N A L O G
÷ The adjustment mode is displayed for approximately 20
seconds.
÷ The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
÷ You can store a separate input level for each input selector.
5 Press the Sound key again to return to the input indication.
32
EN
S O U N D
I N P U T L E V E L
- 3 d B
ACTIVE EQ mode
You can enjoy a more impressive sound effect when ACTIVE EQ is
turned ON.
Press the Active EQ key for the following selections:
1 "ACTIVE EQ MUSIC " : (The "ACTIVE EQ" indicator lights up)
Effective when listening to music.
2 "ACTIVE EQ CINEMA" : (The "ACTIVE EQ" indicator lights up)
Effective when watching a movie.
3 "ACTIVE EQ GAME" : (The "ACTIVE EQ" indicator lights up)
Effective when playing a game.
4 "ACTIVE EQ OFF" : (The "ACTIVE EQ" indicator goes off)
The ACTIVE EQ function is turned OFF.
÷ The ACTIVE EQ function is not available in when the REC
MODE or virtual mode is ON.
Muting the sound
The Mute key lets you mute the sound of the speakers or headphones.
Press the Mute key.
Blinks
To cancel
Press the Mute key again so that the "MUTE" indicator
goes off.
÷ MUTE ON can also be deactivated by turning the VOLUME
CONTROL knob or pressing the VOL +/– keys.