Flame Energy XTD 1.9 Installation And Operation Manual page 54

XTD 1.9 Insert Installation and Operation Manual
Then align the holes in the faceplate extension (M) with the holes in each faceplate side
panels and secure both assembly together using four (4) bolts (D) and nuts (E) provided
(see DETAIL C) .
Note: If the installation of a heat radiation shield is required to reduce clearances from the
shelf and upper surround, refer to Appendix 4: Top Surround and Shelf Heat Shield
Installation (AC01317) prior to the installation of the faceplate on the insert.
Center the insert into the fireplace opening.
Align the notch in the faceplate extension with
the bolt (N) welded to the air jacket (see
DETAIL D) and slide the faceplate assembly
just over the washer (O) and nut (P). Then
push towards the fireplace.
If necessary, adjust the height of the insert
using the leveling bolts on each side of the
convection air jacket until the faceplate is
properly seated on the floor of the hearth
extension.
Once the faceplate is in place, secure the
assembly by tightening nut (P) using a 7/16"
(11 mm) open end wrench.
54