Flame Energy XTD 1.9 Installation And Operation Manual page 53

XTD 1.9 Insert Installation and Operation Manual
Insert the superimposed brackets (G)
and (H) with the screws (F) in the
groove of each decorative trim (I), (J)
and (K) (see DETAIL B). Align the
corners of the angled side of each
trim, and then tighten the screws (F)
to secure the trims.
Align the trim assembly with the left
and right edge of the faceplate and
slowly slide it down over the
faceplate.
Secure the trim to the faceplate by
squeezing the eight trim retainers (L)
between the inner edge of the trim
and the front of the faceplate. As in
the image on the left.
53