Removing The Motor Assembly - JVC KS-F160 Service Manual

QQ
3 7 63 1515 0
Removing the cassette hanger / cassette
holder (See Fig.3)
Prior to performing the following procedure, remove
the FF / REW lever assembly.
1. From the rear of the unit, bend the two tabs f
outwards and disengage the two joints g in the
direction of the arrow.
2. Push the eject lever and remove the cassette holder
from the playback head. Disengage the two joints h
of the cassette hanger / cassette holder and the eject
lever in the direction of the arrow.
3. Lift the cassette hanger / cassette holder and disengage
the joint i of the return link and the eject lever.
Removing the reel disc assembly
Prior to performing the following procedure, remove
the FF / REW lever assembly and the cassette
hanger / cassette holder.
TE
1. Remove the C washer and pull out reel disc assembly. L 13942296513
Replace with a new C washer when
ATTENTION:
reattaching.

Removing the motor assembly

1. Unsolder the two wires j on the motor assembly.
ATTENTION: To replace the sub-belt, remove the
main belt and the sub-belt from the
motor pulley. Then remove the three
screws E and one screw F. Replace
with a new sub-belt while lifting the reel
base assembly slightly.
2. Turn over the cassette mechanism assembly and
remove the main belt and the sub-belt from the
motor pulley.
www ATTENTION: The main belt can now be removed.
3. Remove the two screws G
assembly. .
http://www.xiaoyu163.com
(See Fig.4)
(See Fig.5)
x ao u163
y
attaching the motor
i
http://www.xiaoyu163.com
2 9
8
Cassette holder
Cassette hanger
Chassis
Tab f
Joint g
Tab f
C washer
Q Q
3 6 7 1 3 1 5
C washer
Flywheel (BF)
co
.
Flywheel (BR)
9 4 2 8
Return link
Joint i
Eject lever
Joint h
Joint h
Joint g
Fig.3
0 5 8 2 9 9 4 2 8
Reel disc assembly
Fig.4
Main-belt
Motor assembly
Sub-belt
E
G Motor pulley
G
Soldering j
E
m
F
E
Reel base assembly
Fig.5
KS-F160
9 9
9 9
1-9