Tennant 614214- 3610 Operator And Parts Manual
  1. Manuals
  2. Brands
  3. Tennant Manuals
  4. Blower
  5. 614214-Tennant 3610
  6. Operator and parts manual

Tennant 614214- 3610 Operator And Parts Manual

24” battery sweeper
Hide thumbs
Table of Contents

Advertisement

Quick Links

Model No:
614214-Tennant 3610
614213-Nobles Scout 24
TENNANT COMPANY
701 NORTH LILAC DRIVE
MINNEAPOLIS, MN 55422
MAILING ADDRESS:
TENNANT COMPANY
P.O. BOX 1452
MINNEAPOLIS, MN 55440-1452
CUSTOMER SERVICE:
1-800-982-7658
1-763-513-2850
FAX:
1-800-678-4240
1-763-513-2142
TECHNICAL SUPPORT:
1-800-522-7839
Home Find... Go To..
24" Battery Sweeper
EXT.5356
Operator and Parts Manual
Rev. 00 (03-04)
614201
Cod. PLDC01506

Advertisement

Table of Contents
loading

Related Manuals for Tennant 614214-Tennant 3610

Summary of Contents for Tennant 614214-Tennant 3610

  • Page 1 24” Battery Sweeper Model No: Operator and Parts Manual 614214-Tennant 3610 614213-Nobles Scout 24 TENNANT COMPANY 701 NORTH LILAC DRIVE MINNEAPOLIS, MN 55422 MAILING ADDRESS: TENNANT COMPANY P.O. BOX 1452 MINNEAPOLIS, MN 55440-1452 CUSTOMER SERVICE: 1-800-982-7658 1-763-513-2850 FAX: 1-800-678-4240 1-763-513-2142...
  • Page 2 Home Find... Go To..

  • Page 3: Table Of Contents

    TABLE OF CONTENTS: SAFETY PRECAUTIONS: TECHNICAL CHARACTERISTICS: UNPACKING: MACHINE PREPARATION: MACHINE AND CONTROL PANEL COMPONENTS: USE OF THE ON-BOARD BATTERY CHARGER: STARTING OF THE MACHINE: OPERATIONS TO MAKE FOR CORRECT USE: WASTE HOPPER EMPTYING AND CLEANING: SIDE BRUSH REPLACEMENT: MAIN BRUSH REPLACEMENT: CLEANING AND SERVICING THE FILTER: ACTUATOR FUNCTION: ADJUSTING THE SIDE BRUSH:...

  • Page 4: Safety Precautions

    FOR SAFETY: SAFETY PRECAUTIONS: Do not operate machine: This machine is intended for commercial use only. It is designed to pick up dirt, dry debris and dust from dry - In flammable or explosive areas. hard floor or carpeted surfaces in an indoor environment. It is not constructed for any other use.

  • Page 5: Technical Characteristics

    UNPACKING: - Use manufacturer supplied or approved replacement parts. Unpack the machine carefully avoiding movements that can cause damage. - All repairs must be performed by a qualified Once the machine is unpacked, check the condition of its service person. parts.

  • Page 6: Machine And Control Panel Components

    Handle assembly: MACHINE AND CONTROL PANEL - Release the handle locks as shown COMPONENTS: - Rotate handle into working height position - Return handle lock to the locking position The machine is equipped with a simple panel control that controls all the operational functions of the machine. Unlock Handle lock A) On-Off main switch of the machine...

  • Page 7: Use Of The On-Board Battery Charger

    USE OF THE ON-BOARD BATTERY CHARGER: When the battery on the machine is discharged, the red led on the control panel illuminates and all functions of the machine will automatically stop: the operator must then turn off the machine and start the charging proce- dure by connecting the machine battery charger plug into an AC electrical outlet.

  • Page 8: Waste Hopper Emptying And Cleaning

    session. ATTENTION: This machine is not intended for wet surface sweeping. However, if you encounter a MAINTENANCE CHECK LIST slightly damp environment (moisture buildup on the floor), it is required that you turn the vacuum fan switch off to prevent filter damage. Machine damage The belts for slackening due to wet debris pickup is not covered under The tightness of nuts and screws...

  • Page 9: Main Brush Replacement

    operation out at the end of each work cycle. MAIN BRUSH REPLACEMENT: NOTE: dusty environments - Tilt the machine backwards until the handle is touching If you are using the machine in a dusty environment it is a the ground and the main brush is easily reached. good idea to use the manual filter shaker more frequently.

  • Page 10: Control Panel Display Codes

    CONTROL PANEL DISPLAY CODES: Safety code Cause Actions to take Short circuit brush protection: Reset by turning OFF the stops all functions machine and starting again Dissipater at high The machine resets when temperature. Activates if temperature lowers under 176° F temperature is over 194°...

  • Page 11: Electrical Schematic

    ELECTRICAL SCHEMATIC: Home Find... Go To..
  • Page 12 CHASSIS GROUP Home Find... Go To..
  • Page 13 HOPPER 1016210 RING, RETAINING, D.6, UNI7435 1016167 COVER, NOBLES, TOP W/WARNING LABEL 1016211 SCREW, 4x16, UNI 9707 1016168 COVER, TENNANT, TOP W/WARNING LABEL 1 1016212 SCREW, 4x12, UNI 5937, ZB 1016169 DOOR, TENNNAT 1016213 SCREW, 4x16, UNI 7687 1016170 DOOR, NOBLES...
  • Page 14 BRUSH AND FILTER GROUP Home Find... Go To..
  • Page 15 BRUSH AND FILTER GROUP Ref. Part. No Description 1016265 BRUSH, MAIN, W/LOCKING RETAINER 1016266 MOTOR, BRUSH, MAIN 1016267 PIN, PULLEY 1016230 SHAFT, DRIVE, MAIN BRUSH 1016268 PIN, ROTATION 1016231 ROD, ADJUSTER 1016269 JOINT, ARTICULATED, ADJUSTOR ROD 1016232 GUIDE, ACTUATOR 1016270 MOTOR, BRUSH, SIDE 1016233 ACTUATOR...

  • Page 16: Warranty Policy

    - Travel and labor charges are covered for six (6) months from date of installation. Tennant will, at its option, provide travel (maximum of 3 hours) and labor for repair, or pay for outside repair service in accordance with Tennant Company's flat rate schedule for certain warranty repairs.

This manual is also suitable for:

614213-nobles scout 24

Table of Contents