Control Valve Assembly - Subaru 2001 FORESTER Service Manual

14) Pull rack assembly from cylinder side, and
draw out rack bushing and rack stopper together
with rack assembly.
CAUTION:
Be careful not to contact rack to inner wall of
cylinder when drawing out. Any scratch on cyl-
inder inner wall will cause oil leakage.
(1) Rack bushing
(2) Rack ASSY
(3) Rack stopper
15) Remove rack bushing and rack stopper from
rack assembly.
CAUTION:
Do not reuse removed rack bushing and circlip.
16) Insert ST from pinion housing side and
remove oil seal using a press.
ST 34199AE050 OIL SEAL REMOVER
(1) Press
(2) Oil seal
STEERING GEARBOX [LHD MODEL]
S4M0402A
S4M0163B
PS-37
Power Assisted System (Power Steering)
NOTE:
Discard removed oil seal.

2. CONTROL VALVE ASSEMBLY

NOTE:
Parts requiring replacement are described in the
smallest unit of spare parts including damaged
parts and spare parts damaged. In actual disas-
sembly work, accidental damage as well as inevi-
table damage to some related parts must be taken
into account, and spare parts for them must also
be prepared. However, it is essential to pinpoint the
cause of trouble, and limit the number of replace-
ment parts as much as possible.
1) Using ST, loosen lock nut.
ST 926230000 SPANNER
(1) Lock nut
2) Tighten adjusting screw until it no longer tight-
ens.
(1) Adjusting screw
S601272A0602
S4M0147B
S4M0148B