Power Steering Fluid; Jack-Up Plate - Subaru 2001 FORESTER Service Manual

10. Power Steering Fluid

A: SPECIFICATION
Recommended power steering fluid
DEXRON IIE or III
B: INSPECTION
1) Check power steering fluid for deterioration or
contamination. If the fluid is highly deteriorated or
contaminated, drain it and refill with new fluid.
2) Check joints and units for oil leakage. If any oil
leaks are found, repair or replace the applicable
part.
3) Inspect fluid level on flat and level surface with
engine "OFF" by indicator of reservoir tank.
If the level is at lower point or below, add fluid to
keep the level in the specified range of the indica-
tor. If at upper point or above, drain fluid by using
a syringe or the like.
(1) Check at temperature 20°C (68°F) on res-
ervoir surface of oil pump; read the fluid level on
the "COLD" side.
(2) Check at temperature 80°C (176°F) on res-
ervoir surface of oil pump; read the fluid level on
the "HOT" side.
Non-turbo model
Turbo model
POWER STEERING FLUID
S601275
S601275A22
Manufacturer
B.P.
CALTEX
CASTROL
MOBIL
SHELL
TEXACO
S601275A10
H4M1007
B4M1674A
Power Assisted System (Power Steering)
C: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect battery minus terminal.
3) Remove air intake duct.
4) Drain fluid from the reservoir tank.
5) Lift-up the vehicle.
6) Remove under cover.
7) Remove jack-up plate.
(1)

Jack-up plate

8) Disconnect one pipe joint A from center of gear-
box assembly, and connect a vinyl hose to it. While
turning steering wheel to the left and right, drain
fluid through the hose. Similarly, drain fluid from
the other pipe joint B.
LHD model
(1) Pipe A
(2) Pipe B
PS-101
S601275A18
S4M0380A
S4M0381A