Rack Housing Assembly - Subaru 2001 FORESTER Service Manual

15) After adjusting toe-in and steering angle,
tighten lock nut on tie-rod end.
Tightening torque:
83 N·m (8.5 kgf-m, 61.5 ft-lb)
CAUTION:
When adjusting toe-in, hold boot as shown to
prevent it from being rotated or twisted. If
twisted, straighten it.
C: DISASSEMBLY

1. RACK HOUSING ASSEMBLY

1) Disconnect four pipes from gearbox.
2) Secure gearbox removed from vehicle in vise
using ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox in a vise using the ST as
shown. Do not attempt to secure it without this
ST.
3) Remove tie-rod end and lock nut from gearbox.
STEERING GEARBOX [LHD MODEL]
G4M0132
S601272A06
S601272A0601
S4M0143A
PS-35
Power Assisted System (Power Steering)
4) Remove small clip from boot using pliers, and
move boot to tie-rod end side.
(1) Clip
5) Using standard screwdriver, remove band from
boot.
(1) Band
(2) Standard screwdriver
6) Extend rack approximately 40 mm (1.57 in) out.
Unlock lock wire at lock washer on each side of
tie-rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch rack surface as oil
leaks may result.
(1) Standard screwdriver
(2) Lock washer
S4M0144B
S4M0145B
S4M0146B