ThinkPad T430 User Manual page 112

10. Connect the cables to the new wireless WAN card.
11. Put the memory slot cover back in place
12. Reinstall the battery. See "Replacing the battery" on page 69.
13. Turn the computer over again. Reconnect the ac power adapter and all cables.
Prerequisites for replacing or installing the mSATA solid state drive
Attention: The mSATA solid state drive is very sensitive. Incorrect handling can cause damage and
permanent loss of data. Observe the following guidelines:
• Before removing the mSATA solid state drive, make a backup copy of all the information on it, and
then turn the computer off.
• Do not drop the mSATA solid state drive or subject it to physical shocks. Put the mSATA solid state drive
on a material, such as soft cloth, that absorbs any physical shocks.
• Do not apply pressure to the cover of the mSATA solid state drive.
• Never remove the mSATA solid state drive while the computer is operating, in sleep mode, or in
hibernation mode.
To replace or install the mSATA solid state drive, do the following:
1. Turn off the computer; then disconnect the ac power adapter and all cables from the computer. Wait for
a few minutes, till the inside of the computer cools, before you start the following procedures.
2. Close the computer display, and turn the computer over.
3. Remove the battery. See "Replacing the battery" on page 69.
94
User Guide
1 , close the cover 2 , and then tighten the screws 3 .