Table of Contents
Advertisement
6 Software
6.2.1 PF_GEVPlayer main window
After connecting the camera (see Chapter 2), the main window displays the following controls
(see Fig. 6.1):
Disconnect Disconnect the camera
Mode Acquisition mode
Play Start acquisition
Stop Stop acquisition
Acquisition Control Mode Continuous, Single Frame or Multi Frame modes. The number of
frames that are acquired in Multi Frame mode can be set in the GEV Device Control with
AcquisitionFrameCount in the AcquisitionControl category.
Communication control Set communication properties.
GEV Device control Set properties of the camera head, IP properties and properties of the PLC
(Programmable Logic Controller, see also Section 5.6 and document [PLC]).
Image stream control Set image stream properties and display image stream statistics.
Figure 6.1: PF_GEVPlayer main window
Below the image display there are two lines with status information
6.2.2 GEV Control Windows
This section describes the basic use of the GEV Control windows, e.g. the GEV Device Control
window.
The view of the properties in the control window can be changed as described below. At start
the properties are grouped in categories which are expanded and whose title is displayed in
bold letters. An overview of the available view controls of the GEV Control windows is shown
in Fig. 6.2.
106
Advertisement
Table of Contents
