Kenwood DDX8034BT Instruction Manual page 81

3 Select a speaker type
You can select any of the following speaker
types.
"Center" NONE, 2-3/4x1-9/16 inch, 2 inch, 4
inch, 5 inch, 6-1/2 inch over
"Front" OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4
inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Rear" NONE, OEM, 4 inch, 5 inch, 6-1/2 inch,
6-3/4 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Subwoofer" NONE, 6 1/2 inch, 8 inch, 10 inch,
12 inch, 15 inch over
⁄
• Select "NONE" if you have no speakers.
• If you set the center speaker to "NONE" even in a short
time when you are setting the Surround Control (page
64) to "Bypass+Center", the Surround Control is set to
"Bypass" automatically.
• If you set the center and rear speakers to "NONE"
when you are setting the Surround Control (page 64)
to "Dolby PL II", the Surround Control is set to "Bypass"
automatically.
Crossover Network Setup
You can set a crossover frequency of speakers.
1 Select the speaker to set the crossover
1 1 1
2 2 2
3 3 3
4 4 4
1 Sets the High Pass Filter of the center
speaker.
2 Sets the High Pass Filter of the front speaker.
3 Sets the High Pass Filter of the rear speaker.
4 Sets the Low Pass Filter of the sub woofer.
2 Display the Crossover setup screen
3 Set the crossover
[Phase] Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set
to "Reverse".
Sets the sub woofer phase. (Only when
"Subwoofer" is set to "ON" in Audio Setup)
[HPF FREQ] High Pass Filter adjustment.
(When front, center or rear speaker is selected
on Speaker Select screen)
[LPF FREQ] Low Pass Filter adjustment. (When
Subwoofer is selected on Speaker Select
screen)
[Slope] Sets a crossover slope.
English 81