Monitor Angle Control; Ext Sw Setup; [Angle]; [Ext Sw] - Kenwood DDX8034BT Instruction Manual

Monitor Angle Control

You can adjust the position of the monitor.
1 Display the Angle Setup screen
>
Touch [ ] [ ]
(page 66)
2 Set the Monitor Angle
1 1 1
1 Sets the Monitor angle.
[Memory] Stores the current monitor angle as
the angle during power off.
> >
[System]

[Angle].

EXT SW Setup

Setting up power specification of the external
device for which the power is controlled from this
unit.
1 Display the Angle Setup screen
>
Touch [ ] [
(page 66)
2 Perform EXT SW Setup
[SW Name] Sets the name of the external
device. See <Character Entry> (page 48) for
information on how to enter the name.
[Output Pattern] Sets the power signal output
mode.
( EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time
the button on the EXT SW Control
screen is touched.
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can
be set.
> >
] [System]

[EXT SW].

English 71