Horizontal Crankshaft; Vertical Crankshaft; Choke Control Adjustment (All) - Briggs & Stratton Twin Cylinder L-Head Repair Manual

Remote Control Adjustment –
Pre-Twin II (Type Nos. Below 1100)

Horizontal Crankshaft

1. Move speed control lever to full ''SLOW" position.
2. Loosen control casing clamp at governor control
bracket or intake manifold.
3. Move control casing and wire in direction shown by
arrow, Fig. 7.
NOTE: Carburetor throttle must touch idle speed
adjustment screw when control lever is in
slowest position.
4. Tighten casing clamp screw.
Remote Control Adjustment –
Pre-Twin II (Type Nos. Below 1100)

Vertical Crankshaft

1. Move speed control lever to full ''SLOW" position.
2. Loosen control casing clamp at governor control
bracket or intake manifold.
3. Move control casing and wire in direction shown by
arrow, Fig. 8.
NOTE: Carburetor throttle must touch idle speed
adjustment screw when control lever is in
slowest position.
4. Tighten casing clamp screw.
Choke Control Adjustment – All
1. Place choke control lever on equipment in
"CHOKE" position.
2. Loosen control casing clamp screw.
3. Move control casing and wire until choke is com-
pletely closed.
4. Tighten casing clamp screw, Fig. 9.
4
4
Fig. 7 – Remote Control Adjustment – Pre-Twin II
Horizontal Crankshaft (Type Nos. Below 1100)
Fig. 8 – Remote Control Adjustment – Pre-Twin II
Vertical Crankshaft (Type Nos. Below 1100)
CASING
CLAMP
SCREW
Fig. 9 – Adjust Choke
CASING
CLAMP
SCREW
CASING
CLAMP
SCREW
CHOKE
CLOSED
CHOKE
LEVER