4. Assemble fuel inlet valve to float and install float,
Fig. 28.
NOTE: Float height is not adjustable.
5. Assemble new seal and spacer to throttle shaft
and insert into carburetor body, Fig. 29.
a. Install throttle plate.
NOTE: Use LOCTITE 222 on screw threads.
6. Install idle jet.
7. Install fixed main jet, Fig. 30.
8. Assemble upper body to lower body, Fig. 31.
9. Install fixed main jet plug or fuel solenoid.
a. Torque to 100 in. lbs. (11.0 Nm).
3
FLOAT
FIXED MAIN
JET
Fig. 28 – Install Float
SEAL
SPACER
Fig. 29 – Install Throttle Shaft
IDLE JET
Fig. 30 – Install Jets
Fig. 31 – Install Upper Body
FUEL
INLET
VALVE
11