Paper Loading - DCA Intertel 2000 Technical Manual

Table 3 - Instructions
Using DIP switches SW1-4/5/6 a particular National Character Set can be selected;
this selection modifies the appearance of some characters according to table 10.
Software command "ESC R n" (see further) has priority over DIP-switch selection.
CRLF MODE = ON means that after every CR character (carriage return) sent by the
host, the printer automatically performs a LF (Line Feed) operation.
STAND BY MODE = ON: means that after a certain pre-set inactivity time (default
setting is 20 seconds) the printer switches to stand-by mode with 50% power drain
reduction.
Some of the settings selected using DIP-switches can be modified using software com-
mands; if the DIP-switch settings are changed while the printer is on, the new configu-
ration will be working after the printer is switched off and on.

2.6 Paper Loading

MP 2000 can print on DIN A4/A5 size single sheet paper/forms or multi part paper/
forms or continuous fan-fold paper with hole to hole spacing of 227 mm (8.94").
See figure for correct paper loading.
The procedure for a correct paper loading is the following:
1) Set the printer "OFF LINE" pressing the relevant push-button
2) Open the printer by lifting lever A. (Fig. 1)
3) Insert single-sheet paper module by placing it over the printing plate, checking that
it is equally spaced with the printing area; in case of continuous fan-fold paper, be
sure that the sprockets do engage correctly in the holes provided near to the paper
edges.
4) Close the swivelling printer top and switch the printer "ON LINE".
Paper feeding direction
DCA Intertel 14 DCA Intertel